This tranny is a h22, recently purchase from a seller, but just got it install and it it shift very rough(hard) into 5th gear without starting the car and after starting the car. You can't hear the gear engauge or feel it. First thru fourth feels normal though? Is it a result of a bad tranny? I used 10-30 motor oil for the transmission fluid, could that affect it? I also haven't had the chance to drive it yet as I'm still doing the timing belt. Any input on this.
Announcement
Collapse
No announcement yet.
Transmission install, but shift very rough
Collapse
X
-
Originally posted by TenjiThis tranny is a h22, recently purchase from a seller, but just got it install and it it shift very rough(hard) into 5th gear without starting the car and after starting the car. You can't hear the gear engauge or feel it. First thru fourth feels normal though? Is it a result of a bad tranny? ***I used 10-30 motor oil for the transmission fluid,*** could that affect it? I also haven't had the chance to drive it yet as I'm still doing the timing belt. Any input on this.
Comment
-
10w-30 works fine for our manual trannies though some people prefer gm syncromesh...
edit: check this out http://www.cb7tuner.com/vbb/showthre...smission+fluidLast edited by blackice; 07-27-2006, 04:31 PM.Retired 1990 Accord LX Coupe
Project 240SX
Originally posted by chillin943anyone kno if i can just make a hot wire for v-tec off the horn??
Comment
-
Originally posted by MangoMechaniXYou are kidding, aren't you?
- 1993 Accord LX - White sedan (sold)
- 1993 Accord EX - White sedan (wrecked)
- 1991 Accord EX - White sedan (sold)
- 1990 Accord EX - Grey sedan (sold)
- 1993 Accord EX - White sedan (sold)
- 1992 Accord EX - White coupe (sold)
- 1993 Accord EX - Grey coupe (stolen)
- 1993 Accord SE - Gold coupe (sold)
Current cars:
- 2005 Subaru Legacy GT Wagon - Daily driver
- 2004 Chevrolet Express AWD - Camper conversion
Comment
-
Yeah I hope no one put gear oil in their trannyRetired 1990 Accord LX Coupe
Project 240SX
Originally posted by chillin943anyone kno if i can just make a hot wire for v-tec off the horn??
Comment
Comment