If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
lol pwned, too much backpressure on that exhaust. should go three inch /sarcasm
Besides a shitty weld job, (it is a THIN weld around the ring) I am wondering what else might have caused this. I am going to the JY tommorw to see if I can get another one. I do NOT like Megan anymore. This is the 2nd header I have had issues with.
Besides a shitty weld job, (it is a THIN weld around the ring) I am wondering what else might have caused this. I am going to the JY tommorw to see if I can get another one. I do NOT like Megan anymore. This is the 2nd header I have had issues with.
That is from my lower o2 bung. The o2 sensor came out with that ring attached to it! That ring is what you screw the o2 sensor into. The welds broke and the sensor AND ring came off the down pipe (where the collector is). I just need to get the ring re welded back on so I can screw that dead sensor back into the bung.
That is from my lower o2 bung. The o2 sensor came out with that ring attached to it! That ring is what you screw the o2 sensor into. The welds broke and the sensor AND ring came off the down pipe (where the collector is). I just need to get the ring re welded back on so I can screw that dead sensor back into the bung.
Comment