cp[mike] : 1992 Accord EX

[cp[mike]]

what type of fitting is that that goes into the fuel rail for the guage....ive been looking for a damn fittin that will screw into my fuel rail...where the service port is...with a 1/8 npt female for the guage to screw into but i dont know what the other end should be that screws into the rail

beats me. the banjo bolt and 90° angle both came with the gauge...

perhaps bring the bolt/rail to a hardware store and match it up to the bolts there?

[ceelooboob]

beats me. the banjo bolt and 90° angle both came with the gauge...

perhaps bring the bolt/rail to a hardware store and match it up to the bolts there?

what kinda guage is it.....whered you get it from...also did the the fitting that the guage came with screw right into your rail

[cp[mike]]

what kinda guage is it.....whered you get it from...also did the the fitting that the guage came with screw right into your rail

http://cgi.ebay.com/ebaymotors/92-95...QQcmdZViewItem

[cb7wagonPL]

it says its liquid filled. why? first time i heard of that

[cp[mike]]

it says its liquid filled. why? first time i heard of that

the oil is so engine vibrations dont make the needle vibrate, so you can get an accurate reading while the engine is running.

[mmmBAH]

Caution:

Do not install B&M gauge on the stock fuel rail it will kill it everytime! Install above the fuel filter!

[mmmBAH]

Liquid filled might be the way teh go!

[aww_shiet]

awsome pic!!



i wish my engine bay looked this clean! too bad you live too far away, i'd have you work on my car

[almostJDM]

ive always loved your car mike since i first laid my eyes on her

btw whatd you use to strip all the paint off your VC?

[ceelooboob]

thanks mike

Caution:

Do not install B&M gauge on the stock fuel rail it will kill it everytime! Install above the fuel filter!

why will it get killed if installed on teh fuel rail?

[mmmBAH]

not sure why.. engine vibration?

[ilovemycb7]

Hey Mike, did you paint the WS exhaust black?
Love your car, One of the best here.

[93twodoorLX]

i believe ATX did that in an effort to stealth mode it but mike could tell you better than i could

-sean

[ilovemycb7]

OH, okay. Yeah, I think it looks sweet (well the lack of seeing it) becuase it just makes the car look more sleeper. Nothing on that car hints at the beast it is.

[cp[mike]]

yes, the apexi ws (original style) was painted flat black by steve/atx. the main muffler can is still black, as well as the cut edge of the tip. the only part that lost its paint is the outside of the tip. looks very stealth this way, and since the WS is quiet anyway, its very low-key and it doesnt bring very much attention to the car. the rear end of my car looks just about identical to my old 93 EX sedan; yet now i never get pulled over, while i used to get pulled over all the time in my old car for "loud exhaust." all that had was a STOCK exhaust, with a gutted cat... now, cops ride my ass for a while, then turn some other direction and leave me alone. its nice.

excuse the cell phone pictures.