so my rear main seal is leaking. I am going to get a t2t4 tranny. So I am going to replace it at the same time.
I did this when I put the motor in but obv not very well.
I have a few quick questions.
Do I have to drop the oil pan too? I have an 96 or 97 h22. Its obd2 says 96 on the block. So I don't know which it is. I assume 97 it has the bare aluminum oil pan.
When I replaced it before I just hammered it in. Obv not far enough.
Should I just buy the $45 tool from Honda and do that or take off the whole plate and oil pan.
Last question. I don't see a oil pan gasket on my car currently it looks to be just hondabond. Is this correct?
Oh one more. I went to the dealer to pick up some hondabond they had two type. Hondabond and ultra flange 2.
I got the ultra flange 2 it had a higher temp reading any input on this.
Thanks
Steve
I did this when I put the motor in but obv not very well.
I have a few quick questions.
Do I have to drop the oil pan too? I have an 96 or 97 h22. Its obd2 says 96 on the block. So I don't know which it is. I assume 97 it has the bare aluminum oil pan.
When I replaced it before I just hammered it in. Obv not far enough.
Should I just buy the $45 tool from Honda and do that or take off the whole plate and oil pan.
Last question. I don't see a oil pan gasket on my car currently it looks to be just hondabond. Is this correct?
Oh one more. I went to the dealer to pick up some hondabond they had two type. Hondabond and ultra flange 2.
I got the ultra flange 2 it had a higher temp reading any input on this.
Thanks
Steve
Comment