Headlights wont come on :/

[92a6]

ok so i replaced my f22a1 with another f22a1 with less mile and i did a wire tuck and i got it running and now i just found out my headlights are not working i checked fuses none are blown any ideas?

[AAPOQ]

That's really vague.
Check your bulbs.
Check your wires.
Check your connections...

[wildBill83]

i did a wire tuck ... my headlights are not working

$10 says the problem is in your wire tuck... Did you test the wires before bolting everything up?

[92a6]

i just soddered all the wires and all and they wont come on all connections are good

[92a6]

$10 says the problem is in your wire tuck... Did you test the wires before bolting everything up?

i have one fender on and both sides are ziptied

[evil_demon_01]

ok so i replaced my f22a1 with another f22a1 with less mile and i did a wire tuck and i got it running and now i just found out my headlights are not working i checked fuses none are blown any ideas?

Have you checked for power and earth at the bulb . . .
Which one doesn't it have?

[92a6]

theres no power going to the bulbs in both headlights

[wildBill83]

Then you have a cold solder or bad connection somewhere.

[HardInThePaint]

If you hadn't fucked with the wiring and it was stock then we could possibly help you more with the problem.

I am assuming your lights worked fine before the tuck, so yeah like wildBill83 said it most definitely something with the tuck itself.

You are going to have to go through all of your wiring and make sure everything is everything because apparently you've done something wrong there...

[92a6]

i had to extend the headlight wires for the tuck theres no way around that

[wildBill83]

i had to extend the headlight wires for the tuck theres no way around that

Start diagnosing there then ... See where the power stops at and that is where it is broken.

[92a6]

Start diagnosing there then ... See where the power stops at and that is where it is broken.

but would it cuase both sides to crap out if its just on one side?

[cb7rush]

Most likely its in the wire tuck. And if not it could be your headlight switch or relay

[92a6]

Most likely its in the wire tuck. And if not it could be your headlight switch or relay

how can i see if the relay is bad cuz i couldent pull it out of the fuse box

[HardInThePaint]

how can i see if the relay is bad cuz i couldent pull it out of the fuse box

It'll come out, try removing the relay in front of it (its a smaller relay that pulls right out, I think its the power window relay) and you will see that the headlight relay is held in there on both sides clicked into place. Use a small flathead and pry out the clips on the sides... You'll see what I'm talking about when you look up in there.

IDK, that might be your issue. When you rewired everything you might have blown the relay.