i don't know if this has been covered before.. but here goes.
when the headlights are on, the front corner and bumper lense blink alternately when signalling (bumper, corner, bumper, corner, etc). the bumper blinks in sync with the rear signals, the corner is the alternate.
- i was thinking of tapping the corner into the bumper, but they use different bulbs so that may cause a problem?? also, if i did that, the corner signal bulb would not be always on w/ the headlight, as it is now.
- then i thought about tapping the bumper into the corner, but then they would not blink in sync with the rear signal.
my question is... is there any way to safely wire it so that both front signals blink in sync with each other, AND the rear signal light also? so there would be 3 lights blinking all at once when signalling?
when the headlights are on, the front corner and bumper lense blink alternately when signalling (bumper, corner, bumper, corner, etc). the bumper blinks in sync with the rear signals, the corner is the alternate.
- i was thinking of tapping the corner into the bumper, but they use different bulbs so that may cause a problem?? also, if i did that, the corner signal bulb would not be always on w/ the headlight, as it is now.
- then i thought about tapping the bumper into the corner, but then they would not blink in sync with the rear signal.
my question is... is there any way to safely wire it so that both front signals blink in sync with each other, AND the rear signal light also? so there would be 3 lights blinking all at once when signalling?
Comment