removing grill?

[Lantis]

How do you get the grill off? I found the 5 screws but it seemed to be stuck on the sliding adjusters. I was thinking about taking it off and making it red to match the car.

[coletrain]

Yeah, but it's kinda hard to get back in! I never could get mine back in after I took it off

[Lantis]

would it be easier to do if you did it with the headlights out? and if so, how do you get the headlights out?

[cp[mike]]

Yeah, but it's kinda hard to get back in! I never could get mine back in after I took it off

when you use the screwdriver to pop the clips so you can pull the grill forward and off of the car, the clips are still attached to the headlights. you need to take them out by hand and reinstall them onto the ends of the grille before popping the grill back onto the car. if you leave the clips in the headlights and try to put the grill back on youd never be able get the clips lined up...

[Lantis]

Ok thanks.

I was also thinking about getting a roll of wire mesh and backing the grill with it and also the whole back of the openings in the bumper.. so the whole front openings would be mesh backed..

for 2 reasons,

1 I think it would look good

2 It would keep anything from flying back in there and getting stuck, I don't want trash, bugs, or anything stuck back in there.

so does anyone know how to remove the bumper?

[uncle_el]

to remove the bumper there is a diy in the diy section

http://www.cb7tuner.com/vbb/showthre...ghlight=bumper