relocating fusebox

[91LXcb7]

Ive got a little bit of a start on my wiretuck and had a couple of question on relocating the fusebox.

do u just mark and remove all the wiring from the fuse box itself and then just hook it back up in the proper place once u have the wires on the other side of the firewall? or what?
and
Will the battery to fusebox cable have to be replace or will it have enough extra length and same thing with fusebox to alternator?

[cp[mike]]

the majority of the plugs only fit in one way, in one place... and all the wiring leading to the fusebox is just a handful of regular block connectors that you can pull out... so yeah just disconnect them, reroute all of your wiring where you want it to go, and plug it all back in.

most of the smaller wiring harness wires for like sensors and the fusebox should reach for the most part... its the heavier power wires that youll probably need to do some extending with, like the battery cable and the alternator cable.

[91LXcb7]

thanks mike can always count on u to come through, how would u suggest extending those since they are so big?

[oneoffaccord]

well that depends on what route you wanna go, if u decide to keep the battery the way it is then u will just have to move it around but if u relocate it then u will have to get new wire. as with the alternator u might have to extend or make a new wire from the fuse box to he alternator

[91LXcb7]

battery is stayin in its place for now, what would i need to do to extend that wire though since its so thick

[Shay91Racer]

i would just buy 4-6 gauge wire and wire it to the box then the post

[cp[mike]]

i made another wire with a ring terminal on each end and used a short 10mm bolt and nut to join them...