So i dropped my tranny and the flexplate was broken. Any ideas as to why ? it broke in a perfect circle around the crankshaft. Do i need to worry about it happening again once i replace it?
-
-
that is how i got my cb.Originally posted by troubledrican View Post
previous owner was driving that automatic like a manual
replaced it 5 years ago and all is well -
Wow, that's something I've never seen. I'm sure it doesn't happen very often. Another used one should be fine.Comment
-
Hey guys. So I went to the autostores and they only sell the flywheel for a manual CB. Is this flexplate something I need to get out of the junkyard? I'd rather buy it new but through the dealer will probably cost an arm and a leg. Any suggestions?Comment
-
more than likely since it is rarely heard of being needed to be replaced. If i still had mine sitting after my swap, i'd mail it to you if you covered the cost of shipping but alas, i think i recycled it.
Comment
-
Can you get a picture of the broken flexplate?
Comment
-
cost me $100 at Bronx Honda dealerOriginally posted by troubledrican View Post
here is the listing from manchestermotorsports.com (honda online)
26251-PT2-901 PLATE, DRIVE , PLATE, DRIVE $108.01 Each 1 of this
90023-PA9-000 BOLT, SPECIAL , BOLT, SPECIAL $3.35 Each get 8 of those
90429-PC6-900 WASHER (40X86X2) , WASHER (40X86X2) $12.89 Each 1 of this
95701-06014-08 BOLT, FLANGE (6X14) , BOLT, FLANGE (6X14) $1.00 Each 8 of those
that is what I got and I'm good nowLast edited by bobbycos; 05-23-2011, 01:11 AM.Comment
-
save yourself $100
got to the JY and get one, there will be a cb, with no auto tranny there
just inspect it, if you dont beat on it it wont break
i've seen this a lot on h22/auto swapsOriginally posted by deevergote
"I'm Going For Wood" (Clickey Clickey)
Comment
-
Ok guys went and got myself a flexplate for 15bucks at an auto salvage. I installed it and before putting the tranny back up i started to question why this had happened due to the way the flexplate broke. So i decided to put the converter in the tranny and turn it by hand. Took a while for it to drop in place all the way. But once it was in the tranny did turn but only the converter turned and if i look in where the axles go there was no movement in the gears. Also when the converter turns it is not smooth . there is a grumble when it turns. Could the tranny have locked up wich in turn caused the flexplate to twist right off the crankshaft. here is a link to youtube so you can see how the flexplate broke. http://www.youtube.com/watch?v=G9O8CVuuyWgComment
-
And here is what the transmission sounds like when turned by hand
http://www.youtube.com/watch?v=UK74Yedj2kAComment
-
Wish I could offer you more, but I'd say something is broken.
What was the background noise in the first vid?MRT
37.5 MPG, AC on, cruising at 80.
30.0 MPG, AC on, aggressively driving around 90.
27.5 MPG, no AC, cruising at 90 with occasional gridlock. 40 degrees Fahrenheit
Lots of DIY videos specifically for our car
Get some awesome wipers! <-- It's a DIY
Originally posted by Tippey764Originally posted by deevergoteComment
-
the backround noise is just the flexplate clanging against metal i replaced that part already thats fixed. The tranny is my main concern nowComment
Comment