Clear Tail Lights.

[mondojackal]

LOL


You could tighten them down more, just be careful, if you tighten them too much you'll have to JB Weld the bolt back into the light housing.

[seigneur_rayden]

I was going to make a thread but since there is this one; I am posting the question here.
CPMike, when U say seal all the edges; R U talking about where the Red/Clear meets the chrome housing (blue lines in the picture) OR just where the Red/Clear snaps to the chrome housing (Red Circle in the picture).




Sorry 4 the BIG ASS pics.

[cp[mike]]

i sealed along all areas that you circled... any possible location that would allow water into the tails.

[seigneur_rayden]

Even the area with the blue drawing

[cp[mike]]

Even the area with the blue drawing

especially the gap circled in blue, thats the part that actually does the leaking, i did the red circles just in case.

[seigneur_rayden]

Thanks CPMike.

[Spartan1987]

Here, I resized the pics so we can actually view them.