92-93 harness in 91

[g-wagon]

so it doesn't work.... is there any way i can fix it without getting a new harness on the motor.... like if i can cut and splice connections i'd rather do that... i'd rather trash the car then pull the motor back out...

[cp[mike]]

its not too hard to remove and install a harness while the motor is in the car, just make sure the bracket between the bottom of the intake mani and the back of the block is removed for room. i figured that out the hard way too a while back. upon comparison, didnt look too easy, youd have to rewire most of the harness pins and thats WAYYYY more work than pulling the harness out. thats why i always tell people to use their stock harness when doing a swap, even if its the same type of motor.