ahhh that's tricky. None of the wires are ground, and I had to draw out the individual circuit from the haynes to figure it out.
Anyway to fix it, you need a SPDT relay to short the CIS wires when the remote start sends the status output signal and leaves the wires disconnected when the status signal is removed.
85- batt pos
86- status output
30- one wire of CIS
87- other wire of CIS
87a- empty
Anyway to fix it, you need a SPDT relay to short the CIS wires when the remote start sends the status output signal and leaves the wires disconnected when the status signal is removed.
85- batt pos
86- status output
30- one wire of CIS
87- other wire of CIS
87a- empty
