INT: Sedan Door Panel Removal


Tools needed
Philips screwdriver
Small flat blade

Removing The Front Passenger Panel:
Drivers door is similar


1)Use small flat screwdriver and pop out the clip in the upper front corner.



2)Use a small flat screwdriver and pop up the screw cover in lower rear of panel and remove the philips screw.



3)Use a small flat screwdriver to remove screw cover from armrest pull and remove philips screw.



4)Use a small flat screwdriver and pop up the screw cover behind the pull handle and remove philips screw.




Slide handle forward to front of car to release the hooks and pull towards yourself. Remove door lock switch wire connector(A) and unclip rod(B). Remove door panel screw(C)


After all fasteners are removed, remove panel by pulling with your hands starting at the front and rear bottom of the panel.



After the clips are released, push upward from the rear to unhook the top of the panel.

Unclip the window switch and courtesy light connectors


Reinstall in reverse order

Removing The Rear Panels:

Removing the rear panels. This is similar to the front front but easier.

Remove the interior handle as instructed for the front except there is not a door lock switch to disconnect
Remove the screw behind the interior handle
Remove armrest pull handle screw cover and screw


Pull the panel from bottom to release the clips, then push upward from the rear to remove the panel.


Disconnect power window switch and courtesy light connectors.

Reinstall in reverse order.