Pinchmyhandle : 1993 Accord SE

[Lucien]

I stumbled into a bit of extra money. So I was trying to decide between taking my CB7 in to get the body and paint work done, or picking up a new daily driver so I can put up the CB7 and use it mainly as a show/toy car. What do you all think???

Body/paint.

[cb9love]

Body/paint.

x2

[Pinchmyhandle]

Body/paint.

x2

Thanks you two. I may be doing both. Found a 94 accord for $600. If I get it, then I plan to have a new daily and a paint job for the 93.

[Pinchmyhandle]

Did a little work to the CB tonight. And finally ran the wiring for the Vigor spoiler. It looks so damn good.

[sonikaccord]

Another vigor spoiler member! Welcome to the club. I think I'm going to dip mine black

[Pinchmyhandle]

Another vigor spoiler member! Welcome to the club. I think I'm going to dip mine black

I'm actually gonna dip mine black too. LOL, great minds think alike.

[Pinchmyhandle]

Just picked up a 94 accord I'm gonna use as a daily driver. Got it for $600, runs and drives fine. Needs some TLC, but nothing too crazy.

[Pinchmyhandle]

Only a year apart, yet sooooo different.

[Pinchmyhandle]

anyone have quick release bands on your front bumper? I am putting mine on tomorrow and can't decide where to place them.

[Pinchmyhandle]

Just got my valve cover finished being powder coated. Can't wait to get it on the car.

[Andrewasoar]

Man that accord is CLEAN for $600! Around here that would go for like $1300+.

I personally don't have the quick releases on my car but I actually installed a set today on a CRX and I've been around them on many cars. Just put them right where the bumper meets the fender. Super easy to do and super easy to use.

Also, that VC looks sick!

[Pinchmyhandle]

Man that accord is CLEAN for $600! Around here that would go for like $1300+.

I personally don't have the quick releases on my car but I actually installed a set today on a CRX and I've been around them on many cars. Just put them right where the bumper meets the fender. Super easy to do and super easy to use.

Also, that VC looks sick!

Thanks. The 94 needs all new exhaust, tires, upper and lower valve cover gaskets, and has a bad leak from the power steering pump. So all in all it will be worth it after some elbow grease.

I cannot decide between putting the quick release snaps on the edge of the fender well, or in closer o the center of the front of the fender.

Yes it does, cannot wait to get it on my CB.

[Andrewasoar]

Thanks. The 94 needs all new exhaust, tires, upper and lower valve cover gaskets, and has a bad leak from the power steering pump. So all in all it will be worth it after some elbow grease.

I cannot decide between putting the quick release snaps on the edge of the fender well, or in closer o the center of the front of the fender.

Yes it does, cannot wait to get it on my CB.

That's actually pretty great. Especially if you have some pipes laying around to fab up a quick exhaust for an axleback. I wish my grandmothers 94 didn't get stolen I would've had it along with my CB like you.

To be honest I'm a fan of on the edge. But tape them on and see which one you like more.

[Pinchmyhandle]

OK, got the new valve cover installed, plus a little extra paint under the hood. End result is good, but I have a lot more work to do under the hood.

[Pinchmyhandle]

Also got this done today, lol almost forgot.