If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Rear wheels rubbed the dust covers, those are just bent back. The front wheels barely rubbed on the calipers.
5mm spacers will be put on tomorrow to try again.
But, the wheels are pretty dern flush.
Originally posted by JoshM
The wheels are pretty dern flush. They look awesome.
They rubbed the calipers where the wheel weights were. They were in the actual barrel of the wheel, close to the backside of the face. Nic is going to put wheel weight on the inside lip of the wheel, so that should make the rears not rub at all.
The fronts rubbed the calipers where the weld on the inside of the rim was, but only when the brakes were applied.
So 5mm, or 1/4", should fix that problem.
Trying again today after work...
14"s are a PITA. lol
1999 BMW M3
2001 Honda CR-V SE RT4WD
2005 Chevrolet Tahoe Z71
2015 Suzuki V-Strom 650
The welds of the wheels are rubbing the brake calipers. lol
IMO, they're not too small. They look pretty damn good. My front end will probably be lowered another inch, and the rear will more than likely stay where it is.
1999 BMW M3
2001 Honda CR-V SE RT4WD
2005 Chevrolet Tahoe Z71
2015 Suzuki V-Strom 650
The welds of the wheels are rubbing the brake calipers. lol
IMO, they're not too small. They look pretty damn good. My front end will probably be lowered another inch, and the rear will more than likely stay where it is.
Cool, keep us updated! Can't wait til the wheels are on!
Comment