If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
^ good brake setup! one thing i didn't like about running extended studs is that i can't run wheels with caps anymore.
are you gonna screw down the rotors or not?
yeah sucks! Hopefully I can get something to work out with the studs and a center cap.
I cant screw down the front rotors since the hole doesnt line up on the vtec rotor and cl hub. I will just make sure the rim is on tight so theres no play.
Did you really drill the rear crossmember when you went to get an alignment?
I drilled that bitch out in my garage, with only the back end up in the air. At 1 AM. Got many metal shavings in my eye.
Yes I did, I brought the drill and 15/16 metal drill bit and while they were aligning the car on the lift I pushed in the rear sway to see where I would drill. I drilled then went home after it was done and installed the brackets. hehe.
I tried to drill while I was underneath but it was to hard with the amount of arm space I had.
Comment