Cleaned up my engine bay and video of startup/idle

[vinbon63]

sounds pretty bad ass! I wish we could swap engine's lol.

[Grumpys93]

sounds nice but i would get annoyed of it. I like the engine bay i want to get rid of the big brick. Did you just delete it completely and cap off the vaccum ports or what did you do?

[chessboxer]

sounds nice but i would get annoyed of it. I like the engine bay i want to get rid of the big brick. Did you just delete it completely and cap off the vaccum ports or what did you do?

I made a block off plate for the egr, and the capped off the piece that sits on top of there(the name of it escapes me at the moment)
I then unhooked the black box and looked at which vacuum lines went where, and then I just rerouted them to where they were supposed to go. I removed everything in the black box sans the map sensor, which is still on the firewall.
Thus the vacuum lines now go straight to the IM instead of the the black box and then the IM.
Hope this helps answer your question.

[Grumpys93]

I made a block off plate for the egr, and the capped off the piece that sits on top of there(the name of it escapes me at the moment)
I then unhooked the black box and looked at which vacuum lines went where, and then I just rerouted them to where they were supposed to go. I removed everything in the black box sans the map sensor, which is still on the firewall.
Thus the vacuum lines now go straight to the IM instead of the the black box and then the IM.
Hope this helps answer your question.

gotcha ok ya i already have the egr blocked off i may have to do this i will pm you if i run into any problems if you don't mind. I hate that black box thing to much clutter

[chessboxer]

Sounds good man, just let me know.