ok i seen some peeps who wanna relocate their plates but did it the ghetto way or bolted it on their bumper or used zip ties to hold it. thats cool for those who dont care for cleaness but if u wanna do it and make it look like the quality of the JDM relocate holder shit w/o spending $30 or $40 bucks on it....ur at the right page.
what you'll need:
- (2) L shaped brackets w/ a hole on each end.
- (1) measure tape or a ruler.
- (2) small screws.
- (2) small nuts and bolt.
- a hand power drill.
- 15 mins of your time.
now lets get ready to put this shizzle in...
- first figure out which side u wanna mount the plate on.
*left would be best cuz u dont wanna block the intake*
- now...u will be mounting it under the flat place against the top where your bumper lights are.
- measure the distance of the hole on the license plate and use that measurement and place it on ur bumper and mark the (2) holes of what the measurement was on the bumper.
- now put the plates down and grab a drill w/ the (2) screws and the (2) "L" shaped brackets.
- match the hole on the "L" shaped bracket with the mark u made.
- drill the screw throught the "L" shape bracket and into the bumper.
- do the same with the otherside.
- now match the plate with the other hole in the "L" shaped bracket.
- use the nut and bolt to tighten up the plate.
- now stand back and admire ur JDM license relocator and still having a wallet w/ $40 bucks to treat ur g/f out to a nice meal!
hope i explained it thoroughly.
-BuRRR
what you'll need:
- (2) L shaped brackets w/ a hole on each end.
- (1) measure tape or a ruler.
- (2) small screws.
- (2) small nuts and bolt.
- a hand power drill.
- 15 mins of your time.
now lets get ready to put this shizzle in...
- first figure out which side u wanna mount the plate on.
*left would be best cuz u dont wanna block the intake*
- now...u will be mounting it under the flat place against the top where your bumper lights are.
- measure the distance of the hole on the license plate and use that measurement and place it on ur bumper and mark the (2) holes of what the measurement was on the bumper.
- now put the plates down and grab a drill w/ the (2) screws and the (2) "L" shaped brackets.
- match the hole on the "L" shaped bracket with the mark u made.
- drill the screw throught the "L" shape bracket and into the bumper.
- do the same with the otherside.
- now match the plate with the other hole in the "L" shaped bracket.
- use the nut and bolt to tighten up the plate.
- now stand back and admire ur JDM license relocator and still having a wallet w/ $40 bucks to treat ur g/f out to a nice meal!
hope i explained it thoroughly.
-BuRRR
Comment