Plz Help!!! Crankshaft Pully???

[casterX]

yea but it says from cp mike that there is a rubber seal ... i think thats my problem

yes.. you'd be better of replacing the whole crank pulley and i think that rubber seal/dampener is non-repairable..



here's another link that might help you out..
http://www.cb7tuner.com/vbb/showthre...t=crank+pulley

[blue93cb]

yea but it says from cp mike that there is a rubber seal ... i think thats my problem

I see correct you are.

[91 DX]

yes.. you'd be better of replacing the whole crank pulley and i think that rubber seal/dampener is non-repairable..



here's another link that might help you out..
http://www.cb7tuner.com/vbb/showthre...t=crank+pulley

thanks man ... i have a feeling this is going to be a BITCH!!!! but still thanks for the links

[casterX]

thanks man ... i have a feeling this is going to be a BITCH!!!! but still thanks for the links

it wont, if you have an impact wrench in hand.. gl

[91 DX]

it wont, if you have an impact wrench in hand.. gl

do you know if i need a puller or anything to get it off ?

[casterX]

do you know if i need a puller or anything to get it off ?

i believe you just wiggle and tap it out after you're done with the bolt..

[blue93cb]

apparently there is a special Honda Crank Pulley tool to get the bolt off. I have heard that AutoZone or other parts stores may rent this tool. just from experience. I would definitely use a impact gun.

[sulimed]

put the car in 5th gear. have someone hold the brakes. get an impact socket, braker bar, cheater bar(thick & long one), and a lot force.

[benji]

apparently there is a special Honda Crank Pulley tool to get the bolt off. I have heard that AutoZone or other parts stores may rent this tool. just from experience. I would definitely use a impact gun.

If you have a welder, you can just make that tool... We did. You can use a large hex pipe cap or pipe busing and weld a handle on it, and then cut a hole in the center of the pipe cap so you can get to the crank bolt. Ghetto, but it works suprisingly well. Just make sure to get a long enough handle, or make something that you can add a bar to, because you have to be able to exert as much force on teh handle of the holder as you do on the wrench you use on the bolt.

[4CYLPOWER92]

This tool helps tremendously.

http://www.amazon.com/Alltrade-64879.../dp/B0000TMLWQ

[Bcozzi71]

here is where i got my crank pulley