well car dont start,getting fuel,its turning over but no spark,what does the ignition coil look like so i can test it,does it have the positive + and negative - signs on it oris that something else i have aq 91 so its internal butr were is it in the dits? is it the rdctangle pice with the signs or is itsomething else need to know asap thans.
Announcement
Collapse
No announcement yet.
ignition coil....no start
Collapse
X
-
Take the plug wires off and remove the 3-4 screws (#5) holding the black plastic distributor cap on...then there is a rotor the holds down a plastic looking cover (#9), take a screw driver and pry (GENTLY) it off. The remove the 2 brass screws (#20) holding the ignition coil in the dizzy cap.
Unscrew the 2 wires leading to the coil (#18 and 13) and pull out your ignition coil (#16). To test to see if the coil is good/bad get out a voltometer and I don't remember the resistance but check between the positive and negative posts (where the 2 screws went) and also between the positive and the coil.
That is the best way to describe it. If you look in your chiltons it will also give you a step by step along with ohm readings
CHILTONS or helms = blessing in paper
Last edited by VRDrvr; 07-29-2004, 09:25 PM.No more cb7, 7 years of ownership and 196K on the ticker before she was sold
Current beast: 98 ej8 on 7psi with a 15g turbo and other goodies!
NREMT-B | 300D and some glass
Comment
-
you sure its not the main relay?Originally posted by fizzbob7 i think the "jdm everything" craze is funny........it's the same thing, a fad.......and an overpriced one at that
Originally posted by uncle_el believe it or not, this forum is not about you or your post count. it's about providing relevant information and exchanging it with one another, in order to help build a community. if you don't like that, please leave.
Comment
Comment