Muffler

[SuperTuner12010]

I am going to be building my exhaust in a a week or so and need some opinions.

Im using a F22a6 with dual runners constantly open.My exhaust system will consist of a generic E-bay header with the flexpipe.And a 2 1/2 inch pipe all the way back.No Cat, or resonator.
I already know this setup is going to be raspy but I want to cut down on the raspiness as much as possible.

So im not sure of witch mufller would sound the best.Style wise.
1st contestent the apexi ws2 style

2nd contestent is the evo style i guess

3rd contestent is the most common N1 style

[ExplodingCake]

resonator is what you need.

[SuperTuner12010]

I dont want to restrict the exhaust at all, I dont need inspections so its all good.My brother has a B16 in his civic, ebay header, and pipe all the way back and an Apexi N/A N1 muffler and it is raspy as hell, people call his car the bumble bee because of how it sounds.

So I guess i will need a resonator, were is the best place to put it? About mid section? and what would you reccomend?As well as muffler.

Im looking for loud but little raspiness as possible

[ExplodingCake]

If you are not running an OE cat , it will make the exhaust raspy. Resonators tend to tone down the raspiness a bit. With a combination of OE cat and good resonator , the raspiness might go away. I don't know any good resonators but custom ones will do. Types of mufflers are a factor to. A muffler with a big canister which tones down the sound too.

So your cat is out. One reason of making it raspy as hell.

I'm running a magnaflow muffler and it sounds good , not to loud but close to quiet. I did not use resonators in my setup.

[wed3k]

what you need is a muffler with a LARGE canister. im running no cat and i have no rasp but it is an authentic greddy evo axleback

[SuperTuner12010]

Any mufflers you would reccomend?

[ExplodingCake]

Magnaflow
flowmaster
greddy
apexi
rsr
tsudo

that's all i know lol.

[wed3k]

personally, id throw down for an authentic Apexi WS muffler however it costs around 200 bucks.

make sure the welds are clean with gaskets in between all flanges.