Extracting a Snapped off Crank Pulley Bolt.

[N9netwoAccord]

Well, it has happened to me, I've read the DIY on here, and I'm going to have my uncle attempt to take it out (probably one of the only guys I trust to work on my car if I'm not going to, hes good) and so I'm just wondering, any tips or ideas the will work? I've got lots of cutting fluid, a screw extracter, drill, drill bilts, all that stuff, but just scared to attempt it,

What happens if I can't get this half of the bolt out... is the motor junk?

My uncle may be able to weld another bolt onto the end of the one thats broken off inside my motor and turn it that way, I'm not sure. I'm getting it towed to his house so we can put it in his garage and look and try to figure it out, I'll show you guys some pics of the carnage when I get this problem solved.

[MRX]

i'd probably try welding to it first if u can get in there enough. Thats some bad ass luck u got there tho lo.

[N9netwoAccord]

well guys, the car is good to go again, believe it or not there was 2 snapped of bolts in there, i only knew of one, which i did, but its all set, we used a drill extracter, and some creativity, and its all good to roll, what a relief

[H23CB7]

Good to hear you got her fixed.

[N9netwoAccord]

Good to hear you got her fixed.

yea, me too, definatly a relief!

[djcaz_aom]

That's what I did.

For those looking to see how it is done, I wrote a DIY:

http://www.cb7tuner.com/vbb/showthread.php?t=61123

[N9netwoAccord]

That's what I did.

For those looking to see how it is done, I wrote a DIY:

http://www.cb7tuner.com/vbb/showthread.php?t=61123

i did use that, but my uncle had it pretty much figured out, hes the only guy besides my father and i that i trust enough to work on my car

[NAiL05]

My pee eats up screws thats how powerful that shit is. Fuck pb blaster haha. Anyway glad to hear you got it out.

[djcaz_aom]

I'm glad it worked for you.

LOL NAiL05