Announcement

Collapse
No announcement yet.

clutch problem

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    clutch problem

    I stated my car tonight and i notice my clutch pedel went down further than it normally does. Then when i go to put it in gear the pedel goes to the floor in stays there. When i drove it two days ago it was fine i don't notice any problems at all. And i don't check anything cuz it's to dark. But does anyone know what i should look for 1st.
    "Know Your Rank"


    #2
    Check if you have any clutch fluid in the resevior. If the level is down then have a look down in the drivers footwell for any fluid leaking out of the master cylinder. The bit that the clutch pedal attaches to.
    Members Ride Thread

    Comment


      #3
      As mentioned above have some dot3 or 4 brake fluid ready and make sure its full. MC is also a good thing to check while your at it. When you are not in gear does the pedal move smoothly or does it also hit the ground?

      The New-ish Ride
      My old Ride
      Hear my Vtak!!!
      MK3 Member #3
      I piss off people for fun.
      IA 08 Sunburn Victim #1

      Comment


        #4
        Originally posted by Cam
        Check if you have any clutch fluid in the resevior. If the level is down then have a look down in the drivers footwell for any fluid leaking out of the master cylinder. The bit that the clutch pedal attaches to.
        x2 my clutch did this when i first got the car and i checked my fluid. and it was low. dot 3 brake fluid.
        cant wait till im all done

        Comment


          #5
          i just check my fluid in the resevior was bone dry. So i filled it up with some dot 3 and pump the pedel a million times in i'm back to normal. Thanks for the help
          "Know Your Rank"

          Comment


            #6
            well you didn't take in to much air apparently. which would have caused you to have to bleed the system.
            91 Ex CB9
            JDM h22 auto swap, now w/H23 5spd conversion, short ram intake w/K&N filter, DC ceramic header, 2.25" custom catback exhaust, AMR Engineering coilovers, 205/50/16's Enkei RS5's, front slotted rotors, Xenon body kit.

            W.I.P.
            p72 ecu on Hondata

            To Come
            Weight Reductions
            R33 or R34 front end

            Comment

            Working...
            X