torque specs

[blackcb7]

i need the torque specs for the valvetrain caps that hold the cams down, i searched and found nothing, i would buy a manual, but i need to run the motor right now, any help is greatly appreciated

edit: this is for jdm h22

[Chaos_CB7]

im going to guess and say there the same as the usdm ones.. 8x1.25 mm is 19 lb-ft and the 6x1.0 mm are 9 lb-ft

[blackcb7]

im going to guess and say there the same as the usdm ones.. 8x1.25 mm is 19 lb-ft and the 6x1.0 mm are 9 lb-ft

are you sure, 19 lb seem to little for the valve train, i saw that number but that it was wrong

[Chaos_CB7]

i just copied what it said on Honda IN and if that's wrong then i wouldn't trust taking your car to a Honda dealership. i don't fully trust Haynes or whoevers numbers.

I found out on my f22 that those bolts can easly brake even if you you think there just snugg with a wrench.

[blackcb7]

i just copied what it said on Honda IN and if that's wrong then i wouldn't trust taking your car to a Honda dealership. i don't fully trust Haynes or whoevers numbers.

I found out on my f22 that those bolts can easly brake even if you you think there just snugg with a wrench.

i'm not saying they are wrong, if that is the correct torque, then thnks man

[HondaFan81]

Trust a manual over people IMO..

[Chaos_CB7]

Trust a manual over people IMO..

good advice, i don't know why i just didn't send you the pdf last night.

http://s3.quicksharing.com/v/7422802/1h22_head.pdf.html

[straightedge]

Via ALLDATA Online, those bolts torque to 12 N-m which translates to 8.85 ft/lb or 102.21 inch/lb.

edit: That's for a 94 Prelude H22A DOHC VTEC USDM. There should be no difference in torque specifications, I'm assuming.

[Chaos_CB7]

thats just for the 8 smaller bolts on the ends

[straightedge]

Whoops! Sorry, I was looking at the bolt specs NEXT to the correct one. While if the diagram still works you can see it. SORRY!