The Next PM project... Ideas, and Suggestions.

[FishyMan]

Okay.. I've done the tube seals, valve cover gasket and what not. Took me almost a damn year asking/posting, and finally finding the time/money to do it. BTW, it doesn't tick awkwardly anymore and when I push it, I don't here any whirring or wierd sounds. I am wondering, what I should do next. I seem to be getting a small dab of oil leak, but I'm not sure where it's from. I checked my oil, still good and within range. I have to wipe things down b4 I can really pin point.

Anyhow, I am curious to know what jobs/preventative maintenances are not too bad, and won't require me to purchase TOO much tools. I've done all the fluid changes, and basic stuff like that. I don't wanna mess with anything too costly and hassle right now like removing t-belt to do this and that. Any ideas? inputs?

Or I can get going with the drive axle/rotor/pad. (That'll take me a while)

Thanks.

[starchland]

fuel filter?

also, just go around under the car and pay special attention to tightening down those oil pans bolts.

[FishyMan]

ya i did all those. fuel filter was never the same but it's okay. haha..

thanks..

[mrhonda]

The most common and worst oil leak for F22/H22 is the cam seal, but that reqiures removing the t-belt.....sorry.

[wed3k]

ya, do the drive axle, brakes and pads. pretty easy and you'll get real familiar w/ the whole suspension setup.
blastin off the axle nuts are a bitch though.
i still need to get you the pics of the brake pads huh?

[FishyMan]

haha its cool man.. i have pbrs mm already, but was just curious. ya i have to acquire the prybar, and maybe breaker bar. *must search old threads again.

and yes the cam seal ARGH !!!!!....

well thanks..