So I've made serious progress with this swap. I took the old engine out, wired in the knock sensor, washed the bay with a pressure washer (blue paint jokes aside), and I also swapped out the ps pressure hose with a h23 one. That was a pain in the ass though cause you gotta bend the line to make it work.
I also installed the fuel pressure gauge on the fuel rail, and I installed a stock rear mount. Needed a new front torque mount so I ordered that and it should be here tomorrow. Removed the butterflies from my double stacked plates, now I have just double stacks and no plates.
Here's some pics
I made a little ding here I think when I was removing the engine. Doesn't look like it will affect anything, will it?
I also installed the fuel pressure gauge on the fuel rail, and I installed a stock rear mount. Needed a new front torque mount so I ordered that and it should be here tomorrow. Removed the butterflies from my double stacked plates, now I have just double stacks and no plates.
Here's some pics
I made a little ding here I think when I was removing the engine. Doesn't look like it will affect anything, will it?
Comment