Engine block condition....is it junk?

[Losiracer2]

Yes sir it does!! 5 months later and I still can't feel my pinky or ring finger on my right hand from one fallin on it. Definitely be careful.

yeah i was smart and bought a hoist last night, but it ended up being one made during WWII apparently and weighed like 500lbs by itself lol, but luckily I sold that this morning for a 20 dollar profit. haha next time I'm buying a folding hoist, that one was a bitch to transport.

[wed3k]

you can visually inspect the bearing for abnormal wear or plastiguage its for the tolerances

agreed, oil pan gaskets are cheap and i usually just pull the rod cap off and inspect that. both bearings are usually a mirror of each other.

[bobbycos]

since the engine is on a stand buy a complete gasket/seal set and you won't have any oil or coolant leaks in the future

[Losiracer2]

since the engine is on a stand buy a complete gasket/seal set and you won't have any oil or coolant leaks in the future

I already bought the Felpro complete head gasket set, and I can't return it esp. since the machine shop already installed the valvestem seals.

[blazenem]

hey man if you havent already check the link in my sig. is your car gonna be done by then??
and hows that engine build coming along??

[Losiracer2]

hey man if you havent already check the link in my sig. is your car gonna be done by then??
and hows that engine build coming along??

oh yeah it should be definitely done by then, I just bought the condensor I needed and found a sick deal on a 22 gal air compressor and impact gun so, I'm not equipped with all the tools to get the job done. I say I should be done in about 2 weeks or so w/ that car.