Hmmm, i got my wire going to my ecu think, its not like the stock wiring wires, its kinda like a speaker wire. But the wire from the ecu has the pin and everything. its all connected properly, could the thick wire cause this issue?
-
______________________________
"I ran open header once, it was sooooo loud little kids were running for cover as I was cruising at 2000rpms. That was enough to know I shouldn't floor it." -
it should only be 20-22ga wire.
it should be going to the A4 pin. And make sure your counting pin number from the correct side of the connector.
you should also have Vtec oil pressure switch at D6.
Here is a Pinout- Click Here
My Wiretuck/ Insane engine bay
member ride thread
11.86@120mph T66 turbo 612hp F22A
DIVULGE MOTORSPORTS
People can hate all they want, my f22 is faster than yours.
I have literally been on this site for 10 years, I know what i am talking about!
John 10:18 "No one takes it from me, but I lay it down of my own accord. I have authority to lay it down and authority to take it up again. "Comment
-
changed my wire, that did not help neither.Originally posted by turbo90accord View Post
And yes the green wire (solenoid) is connected to a6
d6 is also properly connected, and ground is correctly wired.
______________________________
"I ran open header once, it was sooooo loud little kids were running for cover as I was cruising at 2000rpms. That was enough to know I shouldn't floor it."Comment
Comment