02 Sensor Wiring problem on H23

[brawl]

Here's the layout of the problem...i have a 90 accord, 96 H23 and 93 P14 ECU...I have everything else wired properly but i keep kicking 2 CELs, 1 and 43. I have re-wired the o2 sensor well over 10 times and can not get the wiring straight...Does anyone know the wiring color for each wire as far as signal and heater +'s and -'s so i can get rid of my CEL's...once it lights up, the car runs like ass on that "preset" fuel curve for the motor.

[brawl]

Well the motor technically is OBDII however the ECU is OBDI and it was previously in a 93 'lude that ran with 1 o2 sensor and was fine...I still haven't found anything on the wiring so whatever help you can lend me is really appreciated.

[brawl]

You might be on to something...i'm just curious though, wouldn't it trip more codes than just 1 & 43?? Figuring just from running an OBDI computer, and she runs great until the CEL pops up.

[brawl]

Well I think i found out the mystery to the o2 code...i had previously tripped EGR codes...I seemed to get rid of them but never got rid of the o2 sensor...then i was reading somewhere the o2 sensor heater + pin location and the EGR valve wire pin location were switched on prelude and accord ecu's...i'm researching that a little more but I have a feeling that might be the end to my problems...if you know anything about this, clue me in since i never heard that before