2 end pistons/rods installed but crankshaft aint turning

[wed3k]

those are the rods i am going to use...i just honed them out to the correct size because i was actually getting interference fit for bearing clearance.

im sure the material would hold up but you pay for what you get.

[jyoungblood87]

...

[jyoungblood87]

those are the rods i am going to use...i just honed them out to the correct size because i was actually getting interference fit for bearing clearance.

im sure the material would hold up but you pay for what you get.

fuc them rods...too much of a headache...thats why im getting these babies from Crower...



just like what one person said on this form...
something that is fast and cheap...aint reliable

something that is reliable and cheap...aint fast

something that is fast and reliable...aint cheap