Intake Manifold Swap questions (fuel and coolant)

[cokinut]

thanks a lot again. i'll check out some liquid steel. I pulled an accordztech and polished up the IM a little bit - what a biatch and lengthy process. I'm going to drill through top of the ports and liquid steel them. Oh and the IM is off the car so everything is a ton easier. i'll keep you guys updated and post some pix too.

FIY: i'm going to try to write a quasi offical h23 IM swap as far as vacuum lines, sensors valves, etc., go.

[91accord4door]

good def go with liquad steel, its in the auto section but you will miss it so keep an eye out, its in about a 5' tube and it sayd "Liquad Steel" on it. its like clay you take a chunk off roll it in your hand and it gets hot and you have about 3 mins before it hardens to a rock. you will see what i mean, but the shit will ast forever. good luck and keep us updated.