as phatdoughnut said maybe you have a bad ground. where did you ground the switch?
Announcement
Collapse
No announcement yet.
Swap's done, but no VTEC!!
Collapse
X
-
Originally posted by timmy0toolas phatdoughnut said maybe you have a bad ground. where did you ground the switch?R.I.P.
AzN VtEc PoWeR (6:38:35 PM): im gonna go shit in someones cereal
Comment
-
Originally posted by EdgarCb7to the thermostat..... but i do see that those two wires that come out of the switch were spliced before... maybe what used to be the ground wire now runs to the ecu and what vise versa... ok so there's a blue wire and a yellow wire coming out the switch, right... so which one should be the ground?
http://www.accordinglydone.com/forum...ead.php?t=9744
VTEC Pressure Switch: Lt Blu on Prelude harness > Pin D6 on ECU // SENSOR LOCATION: Near distributor
Blk/Red > GroundH22 Prelude VTEC 92-96 200 161 10.6:1 87 90 DOHC VTEC 2157 JDM
190.3whp 155 wtq - with bolt ons, and a dc header
ET=14.457 @ 94mph w/ 2.173 60Fter
Comment
-
Originally posted by phatdoughnuthttp://www.accordinglydone.com/forum...ead.php?t=9744
VTEC Pressure Switch: Lt Blu on Prelude harness > Pin D6 on ECU // SENSOR LOCATION: Near distributor
Blk/Red > GroundR.I.P.
AzN VtEc PoWeR (6:38:35 PM): im gonna go shit in someones cereal
Comment
-
sweetH22 Prelude VTEC 92-96 200 161 10.6:1 87 90 DOHC VTEC 2157 JDM
190.3whp 155 wtq - with bolt ons, and a dc header
ET=14.457 @ 94mph w/ 2.173 60Fter
Comment
-
Have you swapped out the pressure switch itself to see if thats the problem?
The New-ish Ride
My old Ride
Hear my Vtak!!!
MK3 Member #3
I piss off people for fun.
IA 08 Sunburn Victim #1
Comment
-
Ahh i see. Oh well that might solve your problem sounds like all the wiring and everything has been covered. Looks like only switch itself now. Hope thats the problem though. Anyone know the spec for the oil pressure switch?
The New-ish Ride
My old Ride
Hear my Vtak!!!
MK3 Member #3
I piss off people for fun.
IA 08 Sunburn Victim #1
Comment
-
try putting the ground somewhere else just for kicks. Make sure the blue wire is going into the ecu in the right location.
Im gona go hit vtec, later.H22 Prelude VTEC 92-96 200 161 10.6:1 87 90 DOHC VTEC 2157 JDM
190.3whp 155 wtq - with bolt ons, and a dc header
ET=14.457 @ 94mph w/ 2.173 60Fter
Comment
-
Originally posted by phatdoughnutIm gona go hit vtec, later.
The New-ish Ride
My old Ride
Hear my Vtak!!!
MK3 Member #3
I piss off people for fun.
IA 08 Sunburn Victim #1
Comment
Comment