If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I am gonna rebuild a h23a1 that I have just recently purchased and I know it needs a bottom end rebuilt, but I was wondering what else should i rebuild to make it quicker?
what type of rods and pistons should I get?
thanks
R.I.P. Molly, you will be missed. Only 16 and your life taken away from an irresponsible driver. (10/14/08)
Sold to: Boost_Lee | Cby0 | CB710AE | CB7lx91 | Davids92Accord | Driftspec310 | F22HB | sunburn | Wed3k
I am gonna rebuild a h23a1 that I have just recently purchased and I know it needs a bottom end rebuilt, but I was wondering what else should i rebuild to make it quicker?
what type of rods and pistons should I get?
thanks
If you're serious, you can bore out to 89mm, or use the stock pistons from an S2000...
Visit us at http://www.valleyspecialists.com for all of your Honda and Acura service needs!
Comment