Automatic to manual swap

[tokomo68]

Just wonderin if this is everything i need to do a complete swap on my accord....hopeuflly ill be able to pick up the parts at a junkyard or pull it from a parts car but i need to make sure that this is all correct as i will be using this as my guide to get the right parts





Parts List
Transmission
Flywheel
Clutch assembly
Slave cylinder
Clutch master cylinder
All lines and dampener from master to slave cylinder
Includes--
line from master cylinder to dampener
dampener, bracket and bolts to hold to fender
rubber line from dampener to adapter on transmission
adapter and bolt to hold to transmission
line from adapter to slave cylinder
bolt that holds rubber line to adapter(banjo-bolt)
Starter for manual tranny
Drivers side CV shaft and intermediate shaft
Transmission mount and bracket
Front motor mount(at radiator)
Rear motor mount(at firewall)
Speedometer sensor (salvage yard may leave it on the tranny)
Shifter cables, holding clips, clevis pins and cotter pins
Shifter cable bracket for tranny (salvage yard may leave it on the tranny)
Shifter assembly
Shifter boot assembly and shift knob
Clutch pedal assembly
Both switches for clutch and their plug-in connectors
Brake and gas pedal assembly
30 Amp Relay
Manual ECU
Bolts Needed
Transmission bolt that goes through starter and bolt below it(the two longest bolts)
Flywheel bolts
Pressure plate bolts
Slave cylinder bolts
Intermediate shaft hanger bolts
Transmission shifter bracket bolts

[That1guyN8]

http://www.cb7tuner.com/vbb/showthre...=&threadid=588

[i'm the girl]

FIRST THREAD at the TOP of the swaps main page.

there's a link in there - and i believe you copy/pasted from that link. thats what you need as long as you don't break anything else.