MAP Sensor??????????????????????

[too.slow.CB7]

my h23a1 swap is hooked up completely and everything is done..... the map sensor was wired into the ecu and the motor runs ok without it then it fails b/c its looking for the map sensor...... then you plug it in and it dies completely... HELP!......... -justin-

[XStrategicDeath]

*bumb*


help this man out

[too.slow.CB7]

my wiring harness was cut so i had to wire it straight to the ecu...... help with the ecu pin-outs it should be wired to b/c i dont know if ive done it wrong..... -justin-

[too.slow.CB7]

need help asap!..... -justin-

[gutterslide]

this is the diagram from the Haynes manual that shows where the map sensor wires go to the ECU.

[too.slow.CB7]

preciate the help..... -justin-