Question on my H22 swap, need help

[masterbarber]

Ok im about to park the wagon this wk now to start my new project. H22 Stage 2 swap. Now my question is;

On the H22 can i use my stock F22 harness? (i know i have to run the Vtec)

Im going from auto to 5 speed, i already have the shifter, shift linkage, pedals, clutch pump, anything else that i need?

[djcaz_aom]

Yes, you can use the stock Accord harness.

[masterbarber]

Thank you, so the only mod at the moment its just the Vtec wiring?

[DariuszZ]

if its obd1 (93-96) then yea, thats pretty much it. If you didnt already, get new timing belt kit, water pump, oil pump, thermostat, etc. Stuff that you can easily change while your motor is out. Also, check your engine mounts. Make sure there not broken.

[GearBangnAccord]

iirc the frame mount needs to be moved to accommodate the manual tranny

[BLUBB2]

Thank you, so the only mod at the moment its just the Vtec wiring?

As far as the wiring,dont forget knock sensor and IABs, hence the P13 will be looking for these.

[moetan]

wiring will work, you will just have some extra plugs that go to the auto tranny. It will be a little more work if you want to switch to a mt harness. The plugs at the strut towers are different to accomodate for the extra wires needed for the at

[nusdogg]

H22 Swap Question 4 a buddy.

Yes, the F22 stock harness should be use.