Stipped brake bolts

[JunyAccord]

I stripped these 14mm bolts on the hub assembly to the brake disc trying to replace the rotors. is there any way i can remove them? should i just bring it to a shop so they can remove them?

['93CB7Ex]

how bad stripped? rounded the corners or complete made it a circle?

[JunyAccord]

its a little rounded around the corners. It can still grip a little bit but as soon as you start torquing it down it spins.

[marcusv8thunder]

http://www.amazon.co.uk/dp/B000QW6K8...SIN=B000QW6K8I

I assume you have the equivalent to these in the US? For something like this they would work, I have a set works well in some situations.

['93CB7Ex]

Get a snap on 14mm wrench

[JunyAccord]

http://www.amazon.co.uk/dp/B000QW6K8...SIN=B000QW6K8I

I assume you have the equivalent to these in the US? For something like this they would work, I have a set works well in some situations.

NICE! that made me get up and drive to the nearest Home Depot and purchase this for $20.00

I will give it a try tomorrow

Get a snap on 14mm wrench

it wont fit because of the hub. the bolt is deep inside the hole

['93CB7Ex]

^ ah. nevermind then.

[JunyAccord]

does anyone know the part number of these bolts? i dont understand the diagram of which bolt is pointing where but i am assuming its number 22?

[theSOB]

looks like #22 to me. did u get them off??

[marcusv8thunder]

NICE! that made me get up and drive to the nearest Home Depot and purchase this for $20.00

I will give it a try tomorrow


it wont fit because of the hub. the bolt is deep inside the hole

good man, hope they worked out for you

[JunyAccord]

good man, hope they worked out for you

hey man i just wanted to say that IRWIN stripped bolt remover works wonders and i highly recommend it for everyone to have in their toolbox. i changed out my bolts and now i'm riding on new rotors. Woot woot!!

[marcusv8thunder]

excellent news, 1+ rep point for me then