Ok so i have pressed out the hubs on both the knuckles, and now i have the bearing, when i press out the old bearing do i need to press in the hub into the new bearing? I hope it fits in without needing to be pressed in.
-
To have loved and lost is better than to have never loved at all #CB7Life -
Yeah, the new one will have to be pressed in. You always can hit them in w/a hammer and a piece of wood between it. Just make sure it goes in straight. -
i need to do my rotors soo bad. The whole car shakes when i brake it sucks
but i have to take the whole thing apart so i can have a shop take the rotors off ;(
It sucks
Comment
-
yeah man i pressed them out with a socket, lol but when i pressed them in the bearing wanted to split so it became loose, now im not going to hammer it more and going to get it pressed in the right way.To have loved and lost is better than to have never loved at all #CB7LifeComment
-
Using a hammer seperates the bearing and damages it. In the best case senerio you'll only get a hum coming from the wheels.Comment
Comment