OEM bushing Kit and some more

[JohnD1079]

Do they sell any OEM bushing kits? or will I have to peice out every single thing from Honda? Also those bushings on the Upper control arm, do they sell them anywhere? I think im gonna be getting the SPC adj. ball joint(Hopefully itll be enough for my neu. race on agx), so im not gonna buy(esp. not for $135 each from Honda), nor need a whole new arm.

Also Where do you guys get your Tie rods from? $50 majestic honda? or someplace else

[JohnD1079]

ohh damn, how could i forget about TAS?

Still not OEM bushing kit though...

[Tnwagn]

As far as I know there is no "OEM" master kit. I think you would have to buy each piece seperately. Or you could just buy a master kit from ES or Prothane and get a little upgrade. ES and Prothane both have their kits in either Polyurethane or Graphite, so you could go either way.

Inner tie rods you can get at like NAPA or Autozone for pretty cheap and they'll last.

[JohnD1079]

I decided agaisnt polyurethane. Ima no maintenance man. I do it right the 1st time, im not gonna take my crap apart to lube them. Plus I think itll be too stiff for me anyway

[ExplodingCake]

Local suto stores tie rod ends are good enough. I got a set installed on mine , so far so good. Better than worn ones.

[starchland]

I would go with something like energy suspension bushing kit...if your on Race springs I doubt these would be to stiff for you.