OKay, here's my situation.
I have a 90 ex, no abs, about 82k. I need to do the following, but since I'm at it, I was wondering what you guys would suggest while I'm at it.
MUST DO:
*Change front brake rotors, pads, recondition pins, etc. (btw i couldn't find the DIY anymore, was it deleted? the one on the pads)
*Replace passenger CV joint. (was thinking of just replacing the whole 1/2 shaft)
So, while I'm at it and taking things apart, what else should I replace? Wheel bearings? Rods? Any suggestion is helpful as I want to replace the necessary majority of things. Maybe bushings on front? I dont' want to replace EVERYTHING, but just mostly the things that are necessary. But of course, if it'll mean my suspension will be better I'll do it.
I only have limited TOOLS, just basic hand tools, ratchets, wrench. I'm planning this out as my 2nd lesson and need some suggestions, ideas. Also, I'm not sure if I can get things to be TIGHT TIGHT, but I hope so, cuz I don't want anything falling off while I'm pushing it or whatevers.
Thanks.
**I'm thinking of getting small parts at hondaautomotive. Any ideas or suggestion of where I can get any parts?
I have a 90 ex, no abs, about 82k. I need to do the following, but since I'm at it, I was wondering what you guys would suggest while I'm at it.
MUST DO:
*Change front brake rotors, pads, recondition pins, etc. (btw i couldn't find the DIY anymore, was it deleted? the one on the pads)
*Replace passenger CV joint. (was thinking of just replacing the whole 1/2 shaft)
So, while I'm at it and taking things apart, what else should I replace? Wheel bearings? Rods? Any suggestion is helpful as I want to replace the necessary majority of things. Maybe bushings on front? I dont' want to replace EVERYTHING, but just mostly the things that are necessary. But of course, if it'll mean my suspension will be better I'll do it.
I only have limited TOOLS, just basic hand tools, ratchets, wrench. I'm planning this out as my 2nd lesson and need some suggestions, ideas. Also, I'm not sure if I can get things to be TIGHT TIGHT, but I hope so, cuz I don't want anything falling off while I'm pushing it or whatevers.
Thanks.
**I'm thinking of getting small parts at hondaautomotive. Any ideas or suggestion of where I can get any parts?
Comment