shaking??WTF

[cb7rush]

How can you check for a bad R/P?

[cb7rush]

what causes this???

the left side studs are out more..

[Losiracer2]

what causes this???

the left side studs are out more..

the right side ones don't look like they're seated completely in the hub, which is bad because if one day you decide to remove you lugnuts, they'll just spin along w/ the stud. Take an old lugnut and tighten it as much as you can or at least until you see the stud pull through even with the other 2 on the left side.

[cb7rush]

the ones on the right are how all the other ones are seated on all four hubs..the ones on the left stick out of my lugnuts??

[GsPaDeZ]

Is it only on that wheel? Could be two different studs...

[cb7rush]

Its only that wheel..
I thought about that wheel having two different size studs on it, but the previous owner didnt do any changes to it..and on the old honda receipts it didnt say anything about studs replaced..

[crashandburn930]

the right side ones don't look like they're seated completely in the hub, which is bad because if one day you decide to remove you lugnuts, they'll just spin along w/ the stud. Take an old lugnut and tighten it as much as you can or at least until you see the stud pull through even with the other 2 on the left side.

YES TAKE CARE OF THIS! simple flat tire about 35 miles from my house turned into some bullshit because of this! blew a tire went to go take the lug nut off hit a hard spot and spun the stud out. i was broke as fuck couldn't get anyone with a trailer so i drove on a flat till i got to a grinder and ground the damn things off. it happened to two lugs on thAT wheel cause i just put new ones on and dint sink them down all the way. big mistake!

[cb7rush]

Update

changed the rack and pinion and most of the shaking has stopped..

The driver side disk is now warped and I either have to get new rotors or turn these.

[cb7rush]

alright guys..update!!

replaced the sway bar end links with ES kit..

car does not shake at high speeds anymore...shakes on braking due to warped rotor(really warped)

thanks for all the people that helped