h23 crower cams

[92accordDx]

hey guys i just was looking around on honda tech for some stuff on the new crower cams they have for the h23 since ive been looking into some for my f22b motor. well he made 161 hp and 158fttq untuned thats pretty bad ass for just cams intake and a header here is the thread and the dyno chart is on there too http://www.honda-tech.com/zerothread?id=1007198

[J-specCb4]

how much do those run i was thinking about webcams regrind

[92accordDx]

ive hurd there around 400 stait from crower but there is no core or anything like that that i know of

[mayberry]

i love your mom

[92accordDx]

lol mayberry is a little tipsy he took it in the ass from his friend lol

[mayberry]

jay loves man balls.

[92accordDx]

lol im not soy hahahahaha

[mayberry]

nuff said!!!!!!!!!

[HondaFan81]

Haven't seen this link before, thanks. However, I checked back on that guy's home page for his car. He basically gained 16 WHP and 10 WTQ with basic mods (stock exhaust), untuned as well. He was also running a 13 deg ignition timing (retarded 2 deg) because of his nitrous setup and was running rich. If he leaned out his fuel map some, advanced his ignition timing (perhaps 2 deg advance) and if need be, played with his cam timing, he would obviously gain more. Overall, these gains were not too bad in my opinion regarding all this.



I can't wait...

[HondaFan81]

ive hurd there around 400 stait from crower but there is no core or anything like that that i know of

Crower stage 1's are regrinds

[92accordDx]

i was saying i wasnt sure if there was a core

[HondaFan81]

After looking around a bit...perhaps the Crower Stage 1's are regrinds, but I have not confirmed this yet. In that link you posted before, I noticed no mention of valvetrain upgrades, that to me is a good sign of a regrind. If it were a billet cam, most likely higher lift and a recommended valvetrain upgrade to go with it. Although, they do weld-ups on core cams as well so

[J-specCb4]

ive pretty much decided against webcams regrind because my buddies exhaust cam broke in half the other day, my guess is that when they welded on the cams that they didnt stress test them correctly for how much heat was applied to them in turn making them weak as hell

[HondaFan81]

ive pretty much decided against webcams regrind because my buddies exhaust cam broke in half the other day, my guess is that when they welded on the cams that they didnt stress test them correctly for how much heat was applied to them in turn making them weak as hell

Did he install them correctly? He torque down the cam holders evenly? What type of cylinder head was this on?

[J-specCb4]

h23a1 from everyhting i know they were installed correctly