F22B DOHC parts worth getting?

[gloryaccordy]

Just thinkin about any parts worth getting for this motor... thinkin, goin thru the engine as a molecule of air

Intake??? BPI flowstack -> 3" piping -> Blox xx mm throttle body, portmatched IM
Head??? Bisimoto Stg II cams, milling
Exhaust??? Bisimoto header ($$$ )/ JDM H22A 2.5" outlet downpipe welded to F22A/F22B flange; 2.5" exhaust

What do you think this motor would do?

[d112crzy]

2.75" AEM CAI.
M2B4 or A4 trans
2.5" exhaust with collector mod

the header doesnt make a huge difference, imo.

bisi stg 2 cams would require you to get springs/retainers.

But if you're looking into milling, I'd do a simple resurface, new stems, and a valve job.

A bored throttle body if you want to make it breath up top. But if that's what you want, then should have opted for the h22.

Read 91Accord-Lx's setup. He has 152whp/147wtq

[gloryaccordy]

2.75" AEM CAI.
M2B4 or A4 trans
2.5" exhaust with collector mod

the header doesnt make a huge difference, imo.

bisi stg 2 cams would require you to get springs/retainers.

But if you're looking into milling, I'd do a simple resurface, new stems, and a valve job.

A bored throttle body if you want to make it breath up top. But if that's what you want, then should have opted for the h22.

Read 91Accord-Lx's setup. He has 152whp/147wtq

Yea I saw 91accord-Lx's setup... I was very impressed. I almost considered getting another F22A but I figured it would be a pain to gather and install all the parts.

The H22 is cool but that swap is just too much $$$. Plus top end isn't that important for me. I want power to the redline but throttle response, midrange, gas mileage and user friendliness are bigger priorities for me.