aleks77's Motor build + turbo setup build (extremely detailed)

[d112crzy]

Small teaser, i put the valve cover on and the turbo manifold and snapped a quick pic of what it will somewhat eventually look like

I hope those oil catch can vent holes are above the valve cover baffling. You're going to lose a lot of oil if they arent.

Our F22 valve covers are designed differently than B series valve covers. The baffling on f22 valve covers is towards the back of it, not the front.

Yours should look like this

[aleks77]

ya i know about the baffle, mine isnt there but a few people have said the amount of oil wont be that much, especially if your catch can is mounted higher than the ports on the valve cover. Im gonna give it a try see if it works, if it doesnt im gonna have to think of something lol

[mickey_601]

seems to be a good build want pics but keep at it finish line in sight

[fatboy1185]

updates?

[aleks77]

update is my ball joint popped out and so did the driver side axle, lucky it happened at 10mph. So gonna fix that asap.

Ordered all my parts, went with Hondata S300 with boost solenoid instead of Crome. Full 3" custom exhaust is gettin installed september 3rd, street tune 4th and dyno the 5th. Thats the plan anyways

[aleks77]

small update, got all the parts today here is a few pix, not pictured is; kteller 3" exhaust, p06 chipped ecu, intercooler piping. The items in the photos are; Magnaflow 3" inlet race series muffler, 880cc precision injectors, walbro 255lph HP fuel filter and kit, gm 3 bar map sensor with pigtail, Hondata S300 with boost solenoid.

[T04ECB7]

when are you going to get pics of the car??? like ones with the intercooler installed and some pics of the motor.

[aleks77]

intercooler is not installed yet, the engine bay looks the same as my pic in my member's ride. However over the next 2 weeks im installing the new valve cover, complete turbo setup, oil catch can, etc. Full exhaust is gettin done on the 9th of september, dyno tune 11th.

[Boost_Lee]

nice updates dude!

yea i suggest baffling the rear like mine. If you must keep those, you can always get someone to weld little baffles by the ports

[aleks77]

thanks lee, thats exactly what i was thinking im gonna try and make little baffles behind the 2 ports, shouldnt be hard

[AccordSe91]

Yes race eng. for pistons. I talked to Bob, had to custom make them to work with h22 rods. Rods i got locally for a crazy price.

what kind of work he had to do to the pistons to fit the h22 rods?
I only found Crower who makes rods for our F22 but it's like 1100$ here..

[HondaFan81]

Good luck on your build, hope things go well. I know you been working hard on it.

[aleks77]

Thanks cisco!

AccordSe91, The wrist pin has to be moved on the pistons, there is a length difference in the rods, here is the info;

Rods Length:
H22A = 143.0mm/5.633
F22A = 141.5mm/5.572

total i paid was $530usd shipped

[aleks77]

Started on the intercooler fitment couple days ago, here is final pic from day 1, day 2 i hacked off a lot more, tuesday night i should have final pix.

[MR.PHIL]

Looking real Nice bro
Homeboy holding the bumper looks kinda creepy with his head down