Announcement

Collapse

Please DO NOT Post In The General Section

From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.


The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.


For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.


Everyone will get a couple of warnings from here on out, after that I just start deleting threads.

Again if you have any questions, PM me or one of the other mods.
See more
See less

And Another Bites The Dust.......

Collapse
X
Collapse
 
  • Page of 2
  • Filter
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
    #16
    ACT gets it for me too.....I have a USED ACT PP and it doesnt even slip on my 6 puck. Grabs hard and fast, and traffic sucks, but i cant complain...


    Formerly 91AccordExR33
    11.68 @ 127mph
    417whp/375wtq
    Sold: 8/2016

    Comment

      #17
      I would just leave it in neutral and hope it rolls sometimes. And I have the HD pressure plate. The XD plate sucks ass for traffic. However, if you dont have over 400lb-ft torque, you really dont need it.

      Comment

        #18
        Ordered my Act 6 puck yesterday.

        I'm still leary because of my last experience with a 6 puck but we'll see I guess.

        I ended up getting the clutch and flywheel for 420.00 shipped off of a company on ebay. I called them and just ordered straight through them and they cut me a sweet deal.

        I'll try and post up after I get it in, I'm not looking forward to the break in period though

        L8r
        Turbo H23a3 build has begun
        01-01-2019

        Comment

        Previous 1 2 template Next
        Working...
        X