Announcement

Collapse

Please DO NOT Post In The General Section

From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.


The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.


For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.


Everyone will get a couple of warnings from here on out, after that I just start deleting threads.

Again if you have any questions, PM me or one of the other mods.
See more
See less

H23 VTEC bin map

Collapse
X
Collapse
 
  • Page of 2
  • Filter
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
    #16
    Got your email. When get a minute I'll take a look and see if I can add anything to help you out.
    MR Thread
    GhostAccord 2.4L Blog

    by Chappy, on Flickr

    Comment

      #17
      Originally posted by GhostAccord View Post
      Got your email. When get a minute I'll take a look and see if I can add anything to help you out.
      it runs pretty good, but i need to use my buddies lift and get that o2 sensor pre-cat out.
      I am in clutch breakin period, so I am running fine for now after checking plugs.

      but I know I could pull more ponies out of this. lowered vtec to 4500.
      that helped the cams breathe better.

      Next week will involve more tuning, since I am going to Chicago this weekend.
      and I get my tuning harness, so I can add all the little extras into my wideband.
      MadLab Racing
      Southern Maryland

      Comment

        #18
        That map is some old school tuning.... Kudos!

        Good luck on the dyno!
        MR Thread
        GhostAccord 2.4L Blog

        by Chappy, on Flickr

        Comment

        Previous 1 2 template Next
        Working...
        X