Announcement

Collapse

Please DO NOT Post In The General Section

From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.


The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.


For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.


Everyone will get a couple of warnings from here on out, after that I just start deleting threads.

Again if you have any questions, PM me or one of the other mods.
See more
See less

injectors?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    injectors?

    maybe someone can give me a answer. im running a po6 ecu chipped and im wondering can i just use High impedance(Saturated) injectors with the resistor box or get peak/hold injectors with the p06 ecu? with it be fine? i ready used dsm 440cc before and had no problems.

    #2
    why not just use the dsm 450cc? or are you upgrading injectors?

    if so i have some evo MR 560cc injectors laying around.

    Comment


      #3
      i probably will but i might just go with new injectors maybe like 550cc. i just want to make sure. thats all

      Comment


        #4
        You should be fine. You can generally run high impedance (low current) injectors on a low impedance(high current) output, but you cannot do the opposite.
        2010 Taurus SHO - Livernois Goodies
        2002 BMW 330 CI Convertible - HUNK OF JUNK

        Comment

        Working...
        X