Announcement

Collapse

Please DO NOT Post In The General Section

From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.


The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.


For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.


Everyone will get a couple of warnings from here on out, after that I just start deleting threads.

Again if you have any questions, PM me or one of the other mods.
See more
See less

H23 Tranny

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #16
    they are selling 6 puck clutches on h-t for 235 shipped, check for HondaEMS
    I <3 G60.

    0.5mm Oversized Stainless valves and bronze guides available. Pm me please.

    Comment


      #17
      Whats a 6 puck clutch do? I think the only thing i can change right now would be rear main seal and a stock clutch. Dont have enough money to buy anything expensive. I have an Exedy stage 2 clutch on the tranny thats on it right now. Could i just swap that over to the H23 tranny? The tranny thats on right now is an F22b SOHC tranny. Lmk. thanks



      My New Ride
      http://www.cb7tuner.com/vbb/showthread.php?t=82630

      Comment


        #18
        How old is the clutch you have now? If not too old or has few miles you should be fine and shouldnt have to change it out. 200 isnt bad at all same price i got mine for just remember you have to drill and tap the holes for the trans mount.
        Jeff

        Comment


          #19
          I think the clutch thats on now only got about 30,000 on it. The tranny has about 100,000 i beleive. Im gonna have to wait for a couple more weeks to get it now. Parents took out 300 from my bank cause of my cell phone bill and insurance. Didnt even let me know. So i have to hold out for another pay check or two. What do i have to tap and drill?



          My New Ride
          http://www.cb7tuner.com/vbb/showthread.php?t=82630

          Comment


            #20
            please search for the diy, i believe its stickied in the diy section, you have been here long enough for you to be able to search

            edit: because i was bored
            http://www.cb7tuner.com/vbb/showthread.php?t=56024
            Members Ride

            Comment


              #21
              Originally posted by Haccord21
              Whats a 6 puck clutch do? I think the only thing i can change right now would be rear main seal and a stock clutch. Dont have enough money to buy anything expensive. I have an Exedy stage 2 clutch on the tranny thats on it right now. Could i just swap that over to the H23 tranny? The tranny thats on right now is an F22b SOHC tranny. Lmk. thanks
              yup, same thing.
              I <3 G60.

              0.5mm Oversized Stainless valves and bronze guides available. Pm me please.

              Comment


                #22
                Alright thanks. I was asking if i had to tap and drill the tranny or something else. Not how to tap and drill the tranny. Thanks though.



                My New Ride
                http://www.cb7tuner.com/vbb/showthread.php?t=82630

                Comment

                Working...
                X