Announcement

Collapse

Please DO NOT Post In The General Section

From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.


The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.


For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.


Everyone will get a couple of warnings from here on out, after that I just start deleting threads.

Again if you have any questions, PM me or one of the other mods.
See more
See less

dsm injector seal question

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    dsm injector seal question

    alright im getting ready to install my dsm turbo kit ...i have the 450cc injectors but i lokd at the seals today and saw that their is two seal in the intake manifold....their is a hard seal and a rubber seal do i have to bore out both of the seals for just the rubber ones?

    #2
    Originally posted by 90_accord_22657
    alright im getting ready to install my dsm turbo kit ...i have the 450cc injectors but i lokd at the seals today and saw that their is two seal in the intake manifold....their is a hard seal and a rubber seal do i have to bore out both of the seals for just the rubber ones?
    just the softer one you can dremel out. There are those on the forum that advise against this, although I have had no problems

    Searching could answer this, especially since I did a how-to on it awhile back
    Shift_BOOST

    BOOM!

    Comment

    Working...
    X