ok, im not shure this was coverd or not, and in the turbo instructions r33 did.. kinda confused me.. how exactly do u install the 450cc injectors?
Announcement
Collapse
Please DO NOT Post In The General Section
From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.
The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.
For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.
Everyone will get a couple of warnings from here on out, after that I just start deleting threads.
Again if you have any questions, PM me or one of the other mods.
The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.
For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.
Everyone will get a couple of warnings from here on out, after that I just start deleting threads.
Again if you have any questions, PM me or one of the other mods.
See more
See less
450cc injectors
Collapse
X
-
1)pop out feul rail
2)take injectors off rail
3)replace with 450's
4)reinstall
5)take razor and cut off center plastic piece (alignment bar) on pig tail (injector plug)
thats all i had to do, plus search, some dude made a thread in DIY that will answer all your questionsMy baby laying down some power...
http://www.youtube.com/watch?v=kd_Q8HSIyqA
-
well i read the o rings need to be drilled out.. are those the ones that are in the intake manifold?
and in the diy one guy says all u need to do is remove a clip.. and they didnt say that was wrong.. this is wat confuses me! no specifics on what to do! wich is it.. do i need to do both.. or one.. or what?*on the lookout for an h22 swapped 5 spd accord*
now for my P.O.S winter car/daily
1992 4dr escort lx hatch
NO MUFFLER-wrx sti tip(got fo free)
5 spd
Comment
-
Originally posted by 90_accord_dxwell i read the o rings need to be drilled out.. are those the ones that are in the intake manifold?
and in the diy one guy says all u need to do is remove a clip.. and they didnt say that was wrong.. this is wat confuses me! no specifics on what to do! wich is it.. do i need to do both.. or one.. or what?Shift_BOOST
BOOM!
Comment
Comment